XD-500 三孔重型打孔机

xd-500三孔重型打孔机使用说明书

1.本机Zui大打孔厚度35mm，孔距83mm，孔径5mm，亦可配4、6、7、8mm冲刀（需订购）

2.依据纸张大小，调整前后左右靠山，设定正确打孔位置

3.经常检查黑色冲孔垫，若有明显凹痕，请用木枇按顺时针或逆时针推动，若无新位置可打，必须更换

4.冲刀亦属耗材，多次使用需适时更换

5.更换冲刀按图示，用木枇逆向拧开m5沉头螺丝，冲刀即脱开，换上新冲刀，拧紧螺丝

6.经常清理纸屑盒

operating instructions of xd-500puncher

1. maximum punching thickness: 35mm, distance between holes: 83mm,

hole diameter: 5mm (alternative: 4mm, 6mm, 7mm, 8mm)

2. adjust and fix the paper according to its size, to get accurate position of the holes.

3. check the black padfrequently, turn it clockwise or counter-clockwise if necessary, and change it when it is broken.

4. punching knife should also be changed when necessary.

5. when change pouching knife, please unscrew m5, change the knife, and then tighten the screw m5 again.

6. please clear the wastepaper box frequently.

技术参数：

孔距： 83mm

孔径： 5mm（4、6、7、8任选）

打孔能力：36mm（500张）