4/5AA 1000MAH 镍镉柱式电池
信息编号:2673741 浏览:102次- 供应商
- 深圳市力仕电池科技有限公司 商铺
- 认证
- 报价
- 人民币¥4.00元每个
- 加工定制
- 是
- 品牌
- ls/产电
- 型号
- 4/5aa
- 所在地
- 深圳市龙华新区大浪街道高峰社区钓鱼台工业区D栋三楼A区
- 联系电话
- 18088881304
- 手机号
- 13570883308
- 联系人
- 王能日 请说明来自顺企网,优惠更多
- 让卖家联系我
产品详细介绍
1、application/描述
this specification governs the performance of the following lux nickel-cadmium cylindrical cell and its stack-up battery。/此规格书包括下述力仕牌圆柱型镍镉单体及组合电池全部性能指标。
model /电池标称:ls –aa600
cell size /单体尺寸:φ14.0±0.5×48.5±0.5(平头)/49.7±0.5(尖头)
2、data of stack up batteries/组合电池的指标
all data involves voltage and weight to stack-up battery are equal to the value of unit cell times the number of unit cell which consisted in the stack-up batteries /组合电池的电压、重量等数据,近似等于组成其单体电池数与对应值之乘积。
example/例如:
stack-up battery consisting three unit cells/电池组包括三个单体电池
nominal voltage of unit cell=1.2v/单体电池的额定电压=1.2v
nominal voltage of stack-up batteries=1.2v×3=3.6v /电池组的额定电压=1.2v×3=3.6v
3、ratings/额定性能
description/项目 |
unit/单位 |
specification/指标 |
conditions/条件 |
nominal voltage/ 额定电压 |
v/ cell v/只 |
1.2 |
|
nominal capacity/ 额定容量 |
mah |
700 |
standard charge/discharge/标准充放 |
standard charge/标准充电 |
ma |
70(0.1c) |
ambient temperature/环境温度: 0~45℃ |
hour |
16 |
||
quick charge/快充 |
ma |
350 (0.5c) |
ambient temperature/环境温度: 0~40℃ |
hour |
3 |
||
trickle charge/涓充 |
(0.05c)~(0.1c) |
0~45℃ |
|
standard discharge/ 标准放电 |
ma |
140(0.2c) |
ambient temperature/环境温度: -20~60℃ humidity:max /Zui大湿度:85% |
dischargecut-off voltage /放电截止电压 |
v/ cell |
1.0 |
|
storage temperature 贮存温度 |
℃ |
-20~40 |
discharged state、humidity、max.85% 放电状态下,Zui高环境湿度85% |
weight/重量 |
gram |
approximate 17 |
3、 performance/电池性能
unless otherwise stated, tests should be done within one month of delivery under the following conditions:/
除非另有说明,测试须在发货后一个月内在下述条件下进行:
ambient temperature/环境温度, t:20±5℃
relative humidity/相对湿度:65±20%
test/测试项目 |
unit/单位 |
specification/指标 |
other condition/其它条件 |
remarks/备注 |
capacity/容量 |
mah |
≥700 |
standard charge discharge/标准充放 |
up to 3 cycles are allowed/允许Zui多三次充放 |
open circuit voltage(ocv)/ 开路电压 |
v/cell |
≥1.25 |
within l hour after standard charge/在标准充电后1小时内测量 |
|
internal impedance/交流内阻 |
mω/ cell |
≤30 |
upon fully charge(l khz)/充满电后(1khz的交流频率) |
|
high rate discharge(1c)/ 1c放电时间 |
minute |
≥57 |
standard charge, l hour rest before discharge by 700ma(1c) to 1.0 v/cell/标准充电后搁置1小时,700ma放电至1.0v |
up to 3 cycles are allowed/允许Zui多三次充放 |
overcharge/过充 |
no leakage nor explosion/无漏液或变形 |
70ma(0.1c)charge 10 days/ 70ma (0.1c)充电10天 |
||
charge retention/荷电保持能力 |
mah |
≥420(60%) |
standard charge, storage:28 days, standard discharge/标准充电后存放28天,标准放电 |
|
iec cycle life/ iec循环寿命 |
cycle |
≥500 |
61951-2◎iec:2001 4.4 |
(see note 2)/ (参见note 2) |
leakage test/泄漏测试 |
no leakage nor deformation/无漏液或变形 |
fully charged at 210ma(0.3c) for 4.0 hour stand for 14 days/210ma充电4.0小时,存放14天后检查 |
|
|
vibration resistance/抗振动 |
there should be no leakage of electrolyte and capacity³nominal capacity./电池无漏液且容量大于或等于额定容量 |
charge the battery 0.1c 16hrs, then leave for 1~4hrs,check battery before/ after vibration, amplitude 4.0mm frequency 1000 times/min any direction for 60mins. standard discharge /将电池用0.1c充电16小时,开路1~4小时,检查振动前后电池状况,振动幅度4.0mm频率1000次/分,任意方向振动60分钟,标准制度放电. |
(续上表)
impact resistance /抗撞击 |
|
there should be no breakage for pvc sleeves, and the capacity should be more than nominal capacity./ pvc外套无破裂,容量大于额定容量。
|
charge the cell 0.1c 16hrs then leave for 1-4hrs,check bat-before/after dropped, height 100cm wooden board (thickness 3 mm) direction not specified,6 times./将电池用0.1c电流充16小时,开路1~4小时,检查掉落前后电池状况,落体高度50cm,3mm厚的木板,6次 |
|
security test /安全测试 |
|
no break nor blast,but allow leakage or explosion /无破裂或爆炸,但允许漏液或变形 |
discharge the cell 0.2c to 0v,then advance current to 1c。discharge the cell 1c 1 hour /将电池0.2c放电到0v。然后,将电流提高到1c,放电1小时
|
|
4、 configuration,dimensions and packings/电池结构、尺寸、包装物
please refer to the attached drawing./参见附图
5、 external appearance/外观
the cell/battery shall be free from cracks, scars, breakage, rust, discoloration, leakage nor deformation.
无裂缝、疤痕、破裂、锈蚀、脏污、漏液、变形
6、 caution/使用注意事项
⑴reverse charging is not acceptable./勿将电池反极充电
⑵charge before use. the cell/batteries are delivered in an uncharged state./初次用前先充电,所提供的电池为未充电态
⑶do not charge/discharge with more than our specified current./避免以高于指定的电流充放电
⑷do not short circuit the cell/battery permanent damage to the cell/battery may result./防止电池短路,以免造成可能的损坏
⑸do not incinerate or mutilate the cell/battery./勿拆解或焚烧电池
⑹do not solder directly to the cell/battery./勿在电池上直接焊接
⑺the life expectancy may be reduced if the cell/battery is subjected adverse conditions like: extreme temperature, deep cycling, excessive overcharge/ over-discharge./如超高温、深度循环、过量的过充、过放电,电池的使用寿命可能会下降
⑻store the cell/battery uncharged in a cool dry place. always discharge batteries before bulk storage or shipment./电池应贮放干爽阴凉处;组合电池或装定前应将电池放电
notes:
(1)approximate charge time from discharged state isfor reference only./以放电态为基准的大致充电时间仅供参考
(2)61951-2◎iec:2001 4.4 cycle life:/循环寿命
cycle no./循环周次 |
charge/充电 |
rest/搁置 |
discharge/放电 |
1 |
0.1c×16h |
none |
0.25c×2h20min |
2-48 |
0.25c×3h10min |
none |
0.25c×2h20min |
49 |
0.25c×3h10min |
none |
0.25c to 1.0v/ cell |
50 |
0.1c×16h |
1-4h |
0.2c to 1.0v/ cell |
cycles l to so shall be repeated until the discharge duration on any 50th cycle becomes less than 3 h./循环至任一第50次放电时间不足3小时为止。 |
|
||
dimension of the cell |
||
类别 |
平头 |
尖头 |
d |
φ14.0±0.5 |
φ14.0±0.5 |
d |
φ8.0±0.1 |
φ4.8±0.1 |
h |
48.5±0.5 |
49.7±0.5 |
"供应4/5AA 1000MAH 镍镉柱式电池"的加工定制为是,品牌是LS/产电,型号为4/5AA,充电时间是15(h),充电电流为200(A),标准电压是1.2(V),额定容量为1000,产品类型是中倍率,外型尺寸为17.0X40.5(mm),适用产品是照明,产品认证为CE