产品名称 | 锂电充电机72V20A 天康 |
---|---|
公司名称 | 天长市天康新能源智能电气有限公司 |
价格 | 1200.00/个 |
规格参数 | 加工定制:是 品牌:天康 型号:7220 |
公司地址 | 安徽省天长市经济开发区经七路西侧天汊路南侧 |
联系电话 | 13805506665 18712020448 |
天长市天康新能源智能电气有限公司
http://www.tkxnyzndq.com email:417540102@qq.com
tel:0550-7309285 fax:0550-7309286
充电器规格书
|
型号:tk-xny-a7220 84v/20a锂电池充电器 (铁壳)
|
|
此型号tk-xny-a7220 340*270*140mm的铁质外壳充电器能在输出84v/20a的情况下工作,具有反接保护功能。
最大输出功率 max.output power | 输入电压 input voltage | 最高输出电压 output voltage | 误差范围 combined regulation | 输出电流 output current | 误差范围combined regulation |
1800w | 80-260v | 84v/±0.2v | ±0.2v | 20a | ±0.2a |
序号no. | 项目item | 技术参数 technical specification | 备注remark |
1 | 湿度humidity | 5~95% | 带包装with package |
2 | 海拔altitude | ≤3000m | 正常工作work normally |
4.1输入特征:
序号no. | 项目item
| 技术参数technical specification | 备注remark |
1 | 额定输入电压 rated input voltage | 220v | 110v |
2 | 电压输入范围 input voltage range | 80-260v | |
3 | 频率 ac input voltage frequency | 50~60 hz |
4.2输出特征和充电模式:
序号 no. | 项目 item | 技术参数 technical specification | 备注 remark |
1 | 恒流 cc(constant current) | ≤84vdc, 20a |
|
2 | 恒压 cv(constant voltage) | 84vdc, 20a↓ |
|
3 | 浮充float stage | 无 |
|
4 | 效率 power efficiency | ≥86% | 输入电压=230vac,额定负载 vin=230vac,rated load |
4.3保护特征:
序号 no. | 项目 item | 技术参数 technical specification | 备注 remark |
1 | 过压保护 over voltage protection | 是 yes |
|
2 | 限压保护 software over voltage protection | 充电器设置的最大输出电压不会超过电池的最大充电电压。 the charger software limits the maximum output voltage to a level suitable for the connected battery system. |
|
3 | 过热保护 thermal protection | 是yes |
|
4 | 限流保护 current limiting protection | 是yes | 恒流 at cc mode |
5 | 短路保护 short circuit protection | 当输出短路时充电器不能正常工作,输出恢复正常,充电器可自行恢复。 short circuit protection should be automatically recovery after remove the condition. |
|
6 | 反接保护 reverse polarity protection | 当输出线接反后充电器不会工作,直到使用者接正确后方可启动。 when output wires are reversely connected to the battery the charger will not operate and will work normally when dc wires are correctly connected. |
|
4.4充电指示
序号no. | 项目item | 状态status | 备注remark |
1 | 电源power on | led1:红灯 red | |
2 | 充电charging | led2:兰灯red | |
3 | 充满fully charged | led2:绿灯 green | |
4 | 输出电压显示 charging voltage display | 是 yes
| |
5 | 输出电流显示 charging current display | 否 no
|
序号 no. | 项目 item | 标准(或测试条件) standard (or test condition) | 备注 remark | |
1 | 耐压测试 electric strength test | 输入-输出 input-output | 1500vac/10ma/1min | 无故障 no breakdown |
2 | 绝缘电阻 isolation resistance | 输入-接地 input-ground | ≥10mohm@500vdc |
|
输出-接地 output-ground | ≥10mohm@500vdc | |||
3 | 泄漏电流leakage current | <3.5ma | vin=264vac | |
4 | 低电压测试 lvd | en60335-1:2002+en60335-2-29:2002 |
|
备注:辨识a:在技术要求范围内,充电器功能正常;
辨识r:只有由外部干扰信号引起的保护装置(保险丝)损坏,整个设备在更换保护装置和重设运行参数后才能正常工作,因机械性损坏和设备故障的设备却不能。
序号 no. | 项目 item | 技术参数 technical specification | 备注 remark |
1 | 最高工作温度 high temperature ambient operating | +40℃ | 性能正常 features ok |
2 | 最低工作温度 low temperature ambient operating | -10℃ | 性能正常 features ok |
3 | 最高存储温度 high temperature storage | +70℃ | 在恢复正常温度2小时后,充电器能正常工作。 work normally after recovery under normal temperature for 2 hours |
4 | 最低存储温度 low temperature storage | -40℃ | 在恢复正常温度2小时后,充电器能正常工作。 work normally after recovery under normal temperature for 2 hours |
5 | 随机振动 random vibration | 20hz to 2000hz 3grms 20hours per axis |
|
6 | 重复震动 repetitive shock | 40g peak 3 orthogonal axes, 3+ and 3- in each axis, 11ms pulse width |
|
7 | 热冲击 thermal shock | -35℃to 75℃,<3min transition, 2.5hours dwell, 200cycle |
|
8 | 跌落测试 drop test | bs en60068-2-32:1993 test ed: free fall appendix b |
|
外壳材质:铁
外壳尺寸:长*宽*高=340*270*140毫米
输入接口:通过iec标准
电源线:1.5米长
输出线: 1.5米长
净重:7.5千克
8.包装,运输方式和存储方式
8.1包装
包装盒内有产品名称,型号,生产厂家名称,安全标准,序号,使用说明书以及装箱单。
8.2运输方式
适用于货车装运,产品需放在阴处,装卸时请小心。
8.3存储方式
当产品不使用时,应放在包装盒内。仓库温度应在-40~70℃,相对湿度为5~95%,并且仓库内不能有有害气体,易燃品,爆炸品,腐蚀性等化学物品及强有力的机械震动、冲击和磁场影响。包装盒需放在距离地面至少20cm高,距离墙,热源,和通风口50cm远。充电器在此种存储条件下可以放两年,超过两年须重新检测。充电器必须每三个月通电一次,通电时间应不少于0.5小时。
9.可靠度需求
mtbf(标准,环境温度,负载要求)≥50k小时;
测试条件:25℃,满载,测试通过值。
本产品的加工定制是是,品牌是天康,型号是7220,输入参数是180-260,输出参数是20A,充电电流是20(A),外形尺寸是340*270*140(mm)