| 产品名称 | 酒精测试仪、气体检测仪/AT6000酒精测试仪现货 |
|---|---|
| 公司名称 | 深圳市工展中心惠嘉展销部 |
| 价格 | 95.00/台 |
| 规格参数 |
加工定制:否 品牌:atmel/爱特梅尔 型号:at6000 |
| 公司地址 | 深圳市华强北路工展中心B2号 |
| 联系电话 | 86 0755 33009011/88391133 13510121188 |
产品简介:
at6000呼出气体酒精含量探测器是专用于测试人体呼出气体中酒精含量的仪器。本机敏感元件采用汉威电子先进的纳米半导体酒精传感器，具有极好的灵敏度和出色的重复性；测试程序由人工智能设计的微电脑控制，工作流程合理，简洁便利，功能齐全，具有多种自适应能力；背光照明的lcd数码、字图显示，直观清晰；小巧的便携设计更便于您移动使用。当被测呼出气体中的酒精含量超过预定值时，本机会自动发出声音报警，为您的安全多一份提醒。
本产品设计、制造、检验遵守以下国家标准：
gb/t21254-2007《呼出气体酒精含量检测仪》
gb19522-2004《车辆驾驶人员血液、呼气酒精含量阈值与检验》
特点:
◆ 先进的纳米半导体酒精传感器；
◆ 响应、恢复迅速、检测快捷方便；
◆ smd装配工艺，性能稳定可靠；
◆ 人工智能微电脑控制；
◆ 测试过程屏幕直观显示；
◆ 蓝色背光照明的lcd数码、字图显示；
◆ 便携设计、小巧轻便；
◆ 酒精超限自动声报警；
◆ 传感器故障自检；
◆ 智能节电设计，电池欠压指示
主要技术参数:
| 型 号 | at6000 |
| 传感器类型 | 纳米半导体酒精传感器 |
| 工作电压 | dc4.5v（3×aaa电池） |
| 欠压指示 | vcc＜3.30v±0.10v显示欠压；vcc＜3.00v±0.10v欠压关机 |
| 工作电流 | ≤120ma |
| 使用环境 | 温度： -10℃～50℃ 相对湿度：≤95% 无结露 |
| 测试响应时间 | ＜5s |
| 预热时间 | ＜20s |
| 测量范围 | (0.00～1.00)mg/l(0.00～0.20%bac；0.00～2.00g/l) |
| 报警浓度 | 0.24mg/l(0.05%bac； 0.50g/l) |
| 精 确 度 | ±10% f.s |
| 报警方式 | 声报警 |
| 显示方式 | 带蓝色背光的3位 lcd 数字配合图文显示 |
| 重 量 | ≤64g (不含电池) |
| 外形尺寸 | l×b×h，mm ：103×65×27 |
| 颜 色 | 黑色 |
digital indication:
8.8 8 | alcohol content |
“c” shows circularly on the lcd | ready for blow |
“ ”shows circularly on the lcd | analyze the concentration, please wait |
fff | sensor fault |
2. operation instruction
2.1. slide down the battery compartment on the back side, insert 3pcs aaa 1.5v batteries inside according to battery polarity indication and close it.
2.2. press the switch button and last for 1s, the tester would be power on with a buzzer brief ringing, ‘wait’ shows on down side of screen, meantime it shows 100 to 000 countdown, please wait now, otherwise its accuracy will be not good.
until “wait” disappears, tester will send out a ring,meantime shows “blow” and “c” gliding, now the test could begin.
remarks: its countdown speed will depend on concentration of last test, if concentration is high, it will be slow. if concentration is low, the countdown will be very quick.
2.3. have a deep breath before testing, and blow directly to gas entry when “c”circularly shows, stop blow when heard its buzzer ring.
2.4. after blowing finished, the lcd screen willshow “ ” circularly, meantime shows “test”, this means the tester is analyzing the result, do not blow at this time. after analyze the screen will show the testing results.
it will turn off automatically after keep results for several seconds.
2.5. if a new testing needed, press the switch button again and repeat the above step 4.2～4.4.
3. notification
3.1. avoid any fall or strong shock.
3.2. if noise gas with high concentration existed,may the tester won’t work normally.
3.3. if testing is done under low voltage, certain error will be existed between the real value.
3.4. to ensure the testing result, please wait 15 mins to take the testing after your drinking.
3.5. the result may be unreliable for your first test if long time storage, please try second time.
3.6. do not keep the tester in the environment of corrosive gas (chlorine etc) for use or deposit, also in other bad surroundings.
3.7. do not blow smoke to tester directly, especially the smokers.
3.8. when in consecutive testing, if blow immediately after drink, this concentration is very high, there will be some rudimental in mouthpiece. please wait for at least 1 min to take second test, or, blow clean air for 3 seconds to clean out its mouthpiece.
3.9. after long time use, there may be dirt on the tester, please use clean cloth to wipe off. do not use any hard object or the solvent with any corrosive ingredient.
remarks: common fault and solving solutions
fault | possible reason | solution |
no display on lcd | incorrect battery installation | insert battery correctly according to polarity |
low battery seriously | new battery replacement | |
circuit fault | contact distributor | |
no response to detection gas | not completewarm-up | waiting completewarm-up |
circuit fault | contact distributor | |
fff display then power off | sensor fault | contact distributor |
low voltage display then power off | low battery seriously | new battery replacement |
to keep the continuous improvement of the products, we reserve the right to improve design without prior notice.
"批发酒精测试仪、气体检测仪/AT6000酒精测试仪现货"的电压为4.5（v）（v），尺寸是103*65*37（mm）（mm），预热时间为15（s）（s），加工定制是否，测量范围为0.00-0.20，测量对象是饮酒人员，类型为呼吸式酒精检测仪，重量是0.064（kg）（kg），型号为AT6000，测量精度是0.01，分辨率为0.01，品牌是ATMEL/爱特梅尔，反应时间为5（s）（s），电源是dc