风机盘管电动阀 HY-G2

hy-g2型电动阀用于控制冷水或热水空调系统管道的开启或关闭，达到控制室温之目的。控制阀由单向磁滞同步电机驱动，弹簧复位。阀门不工作时处于常闭状态，当需要工作时由温控器提供一个开阀信号，使电动阀接通交流电源而动作，开启阀门，冷冻水或热水进入风机盘管，为房间提供冷气或暖气；当室温达到温控器设定值时，温控器令电动阀断电，弹簧使阀门关闭，从而截断进入风机盘的水流。通过阀门关闭和开启，使室温始终保持在温控器设定的温度范围内。

产品特点:

锻压黄铜阀体

不锈钢基座、铝外壳

功耗小、噪音低

分体电动阀驱动器和阀体采用卡扣连接，

采用全封闭单向磁滞同步电

不需要任何工具就能简单快速地拆卸、安装使用十分方便

电机驱动，不锈钢弹簧复位。　

技术指标：

电源电压：220v±10％50/60hz

阀门动作时间：开启时间＜10s复位时间＜6s

自耗功率：＜7w

工作环境条件：5～60℃10％-95％rh不结露

公称压力：1.6mpa

介质温度：5～90℃

hy-g2 electric valves used to control the cold water or hot water pipe air conditioning system turned on or off, to control room temperature purposes.control valve hysteresis synchronous motor drive by the one-way, spring return.when the valve does not work in a normally closed state, when the need to work by the thermostat to provide an open valve signal to the electric valve connected to ac power and action, open the valve, chilled water or hot water into the coil, as the roomprovide air-conditioning or heating; when the temperature reaches the thermostat setting, the thermostat so the electric valve off, the valve spring to close, thus cutting off the flow of water into the fan coil.through the valve closing and opening, the thermostat temperature is always maintained at the set temperature range.
features:
forging brass body
stainless steel base, aluminum casing
power consumption, low noise
split electric valve actuators and valve with snap connection
a fully enclosed one-way hysteresis synchronous motor
does not require any tools can be simple and fast to disassemble, installation is easy to use
motor drive, stainless steel spring return.
specifications:
power supply voltage: 220v ± 10% 50/60hz
valve action time: open time <10s reset time <6s
since power consumption: <7w
working conditions: 5 ~ 60 ℃ 10% -95% rh non-condensing
nominal pressure: 1.6mpa
medium temperature: 5 ~ 90 ℃

hy-g2 electric valves used to control the cold water or hot water pipe air conditioning system turned on or off, to control room temperature purposes.control valve hysteresis synchronous motor drive by the one-way, spring return.when the valve does not work in a normally closed state, when the need to work by the thermostat to provide an open valve signal to the electric valve connected to ac power and action, open the valve, chilled water or hot water into the coil, as the roomprovide air-conditioning or heating; when the temperature reaches the thermostat setting, the thermostat so the electric valve off, the valve spring to close, thus cutting off the flow of water into the fan coil.through the valve closing and opening, the thermostat temperature is always maintained at the set temperature range.
features:
forging brass body
stainless steel base, aluminum casing
power consumption, low noise
split electric valve actuators and valve with snap connection
a fully enclosed one-way hysteresis synchronous motor
does not require any tools can be simple and fast to disassemble, installation is easy to use
motor drive, stainless steel spring return.
specifications:
power supply voltage: 220v ± 10% 50/60hz
valve action time: open time <10s reset time <6s
since power consumption: <7w
working conditions: 5 ~ 60 ℃ 10% -95% rh non-condensing
nominal pressure: 1.6mpa
medium temperature: 5 ~ 90 ℃