loctite5920 平面密封硅橡胶

具体价格面议

乐泰硅橡胶平面密封具有耐介质性能，高温作业配方以及紫外线固化配方，满足现场固化制造条件的独特产品。

硅橡胶垫片产品Zui适用于较大缝隙应用作业以及抗挠性法兰和金属冲击法兰的装配。

基本性能

典型用途：高温

颜色：黑色

缝隙填充：6.09mm

压出速度，克/速度：600

温度范围：-54°c到260°c

固化方法：湿气固化

固化速度：表干60分钟，完全固化24小时

比重：1.34

肖氏硬度a:31

延长率%：355

抗拉强度：275     

  product description
loctite® product 5920 is a one component, room
temperature curing rtv silicone non-sag paste formulated for
low volatility applications, as in oxygen sensor equipped
general motors’ engines. good for applications up to 350°c.
typical applications
this product is used to fill voids and irregularities in surfaces
for a positive seal. it adheres to metal, glass, natural and
synthetic fibres, wood, ceramics, other silicone rubbers,
pointed surfaces and many plastic substrates. product 5920
can be used on all assemblies where an engine manufacturer
recommends room temperature vulcanising (rtv). it is also
used for electrical insulating applications.
approvals
this product meets general motors’ silicone volatility
specifications.
properties of uncured material
typical value
chemical type oxime silicone rubber
appearance metallic copper paste
specific gravity @ 25°c 1.05
viscosity @ 25°c thixotropic paste
flash point (tcc), °c >93

  general information
this product is not recommended for use in pure oxygen
and/or oxygen rich systems and should not be selected as
a sealant for chlorine or other strong oxidising materials.

  directions for use
clean mating surfaces to remove all traces of oil and old
gasketing material.
note: do not use petroleum cleaners such as mineral
spirits, kerosene, or gasoline to clean parts as they
will leave an oily film.
apply product 5920 in a continuous bead around all holes and
perimeters of the mating parts. assemble parts together while
sealant is still wet (approximately 10 minutes). place and
torque bolts.
sealant will become tack-free in less than one hour, and will
cure to a depth of 6mm (1/4 inch) within 24 hours.

 storage
product shall be ideally stored in a cool, dry location in
unopened containers at a temperature between 8°c to 28°c
(46°f to 82°f) unless otherwise labelled. optimal storage is
at the lower half of this temperature range. to prevent
contamination of unused product, do not return any material to
its original container. for further specific shelf life information,
contact your local technical service centre.

                          更多产品性能，可咨询深圳市鹏科泰贸易有限公司

                                电话：0755-86381816

                                传真：0755-86381822

本产品的分类是硅橡胶，品牌是乐泰，型号是5920平面密封硅橡胶，粘合材料是金属，玻璃，天然和合成纤维，木