东莞市供应油压式胶头閘 油压式胶头閘

characteristics

1. the german abb motor and siemens electrical appliances.

2. germany rexroth hydraulic system.

3. taiwan oil cooler, germany oil cylinder.

4. large glue head, plank, plastic products cut, recycling.

the hydraulic installation manual. touzha glue

1. the first will glue touzha enshrined in a fixed position, had better be the independent room (to prevent blob of splash hurt), four corners must smoothly, any one horn cannot fail.

2. the power supply received mechanical connection, determine &type normal. check engine rotation direction and indicator direction is consistent, exchange the wires position try once again.

3. check the oil cylinder diameters, confirm that the amount of oil in the available scope.

4 the hose connection to cooling system, remember when stop off water pipes.

instructions

1. everything is ready, then starts to work.

2. to manually lifting switch, make knife cutting materials, pay attention to decline begin blob of bottommean contact, blob of sliding side. if not, can not go down a pressure rises again pressed again down until pierced open so far in doesn"t open. truthfully change another part of nature.

3. cut materials as note pressure gauge shows, pressure should maintain 180kg/cm in ² below normal working pressure, set for 150kg/cm ² and vice should lead to motor load damage.

warrenty ordinance:

1, party a sells the mechanical equipment, and party b under normal use warranty period of one year, with one year; rinou reinsurance

2, if party b will these mechanical equipment in abnormal use cases use damaged, party a shall be charged damage spare parts cost cost, artificial cost neglected.