供3M945灯箱布 1.22*45.7

质量保证：9年

description
application and end uses
3m™ panaflex™ awning and sign facing 945 gps
is intended only for these applications. any other
application is not warranted by 3m or covered by
the worldwide 3m™ mcs™ (matched component
system) warranty unless 3m gives its prior written
approval for the application.
· create attractive day and night graphics for use
in many types of signs and awnings
· attach to variety of framework
· decorate before or after attaching to the
framework
limitations of end uses
· decorate only the front surface of this substrate
· for the best looking signs and awnings, do not
remove and then re-use panaflex awning and
sign facing 945 gps. redecorating and re-using
the substrate is not recommended or warranted
by 3m
· 3m commercial graphics division products are
not tested against automotive manufacturers’
specifications and are therefore not warranted
for use in fabricating graphics for automotive
original e manufacturers (oem)
product line
panaflex 945 gps substrate is available in the
following standard lengths and widths:
standard widths lengths*
seamless
101.6; 122; 137; 165; 203cm
(3ft 4in; 4ft; 5ft; 6ft 8in)
7 metre minimum *
(20 feet minimum)*
seamed
213cm - 914 cm in 182cm
sections
(7ft - 40ft in 6in increments )
13 m2 minimum *
(140 square feet min. *)
*total area per roll cannot exceed 139.5 m2 (1,500 sq ft)
notes:
1. roll widths up to 203cm (80 inches) are seam
free.
2. roll widths wider than 203cm are fabricated
using 203cm material seamed at 200cm centres
+1.3 to 2.5cm. all seamed rolls begin and end
with a full 203cm panel. the maximum seam
length is 12.2m.
3. seam free roll goods are shipped subject to the
limitations contained in the roll map that is
shipped with each roll. please refer to this roll
map in determining suitability for intended
purpose.
4. panaflex substrate, 203cm or less in width, may
contain the low visibility splice. this patent
process makes it possible for 3m to offer
continuous rolls of panaflex™ substrate that is
all useable. the low visibility splice will be a
minimum intrusion into a back-lit graphic.
! caution: if you are seaming this material
into larger sizes, do not include
the splice in material to be
seamed. splices cannot be used
in seamed faces at this time.
do not allow a splice closer than 120cm (4 feet) from
a mounting clamp or material support.
standard seam
all rolls or custom sign blanks wider than 203cm are
fabricated using a 3m manufactured standard
overlap seam. this seam must be located a minimum
distance of 45cm (18 inches) from any attachment
hardware to prevent creating high stress forces
under wind load conditions.
panaflex 945 gps substrate is distinguishable from
other brands of flexible materials by the
identification printed on the backside and white
pigmented front and back surfaces. also, the front
surface of the material is smooth and exhibits a
semi–gloss level similar to that of scotchcal 3630
series translucent film.