多位移动式插座机械强度试验装置 MO-1 插座强度测试

多位移动式插座机械强度试验装置MO-1 Mobile outlets mechanical strength tester MO-1 产品概述：本装置符合GB2099-2008图29、IEC60884图29标准要求，适用于检查可拆线的多位移动式插座上Zui轻型软缆的机械强度。 试验原理：将软缆自由端固定到墙上，固定点离地面的高度为750㎜，将试样抓住，使软缆处于水平状态，然后使试样跌落到混凝土地板上8次，每次跌落后，在固定点处将软缆转45°角。试验之后，试样应不出现标准意义上的损坏，尤其是部件不得松动或脱落。 Products Information Product Overview: This device complies with standard requirements of GB2099 - 2008 (Figure 29) , IEC60884 (Figure 29) , applicable for the test of mechanical strength of the lightest soft wire in the rewirable mobile socket. Test principle: fix the free end of soft to the wall, the fixed point is of 750 mm height from the ground, grasp the specimen to make the soft in the state level, and then drop the sample to the concrete floor eight times. Each time after falling, on the fixed point turn the soft cable to a 45 ° angle. After the test, the sample should not be damaged in the standard sense; especially parts shall not be loose or fall off.